Seat Pan

To much suprise, the CC boys accomplished what they actually planned to do, yet to be honest it was after much thought and fart arseing about.
Setting out to make a seat pan it was planned to attempt to make a lightweight fibre pan, but neither thought to act and order any material .. . So it was to be made out of thin steel, yet there was none left .. . Then walking past it every shed session Luke saw some seat pan material!!

Chequer Plating!! Good ol' ali chequer plating.

Lightweight, flexible and pretty cool looking it was perfect. It was measured, cut out then cut some more (never measure twice, cut once in the CC house) and angled to accomidate the rear frames stylish lip.

All to do now is to fit it with a hinge system and get it covered.

No comments:

Post a Comment